Connecting An Antenna Or Cable Tv (No Box) - Insignia NS-37D20SNA14 User Manual

Insignia 37" LED TV

Connecting an antenna or cable TV (no box)

On your TV
Coaxial cable
connector
ANT/CABLE IN
jack
To connect an antenna or cable TV (no box):
1 Make sure that your TV's power cord is unplugged and all connected equipment is turned off.
2 Connect a coaxial cable (not provided) to the ANT/CABLE IN jack on the side of your TV and to the antenna or
cable TV wall jack.
3 Plug your TV's power cord into a power outlet, then turn on your TV.
4 Press INPUT to open the INPUT SOURCE list.
5 Press or to highlight TV, then press ENTER.
6 If you cannot tune to channels you know exist, scan for channels. See
page 42.
Notes
• Use a coaxial cable to eliminate interference and noise from radio
• Do not bundle the coaxial cable with the power cord or other cables.
• If the antenna is not installed correctly, contact qualified service
• If the signal level for a channel is weak, the picture may be distorted.
• If the picture quality is good on some channels and poor on others, the
• If you connect to cable or satellite TV without a set-top box and
• Many high-definition (HD) channels upscale standard-definition (SD)
Antenna or cable TV
(no box)
Coaxial cable
waves.
personnel to correct the problem.
Adjust the antenna or use a highly directional outdoor or set-top
antenna with a built-in amplifier.
problem may be caused by a poor or weak signal from the broadcaster
or cable TV provider.
experience poor picture quality, you may need to install a set-top box to
improve signal reception and picture quality. Contact your cable or
satellite TV provider about upgrading to a set-top box.
content. The picture displayed on your TV is still displayed as SD, thus
the picture quality will not be as clear or crisp as it would be if the
content was originally recorded in HD.
www.insigniaproducts.com
Side of TV
"Automatically scanning for channels" on
17