Table of Contents
Advertisement
NOTE:
The thermal material must be thoroughly cleaned from the surfaces of the system board (1),
(2), and (3) and the heat sink components (4), (5), and (6) and must be replaced each time the heat
sink is removed. Replacement thermal material is included with all heat sink, system board, cable,
and processor spare part kits.
RJ-45 (network) jack
NOTE:
The Cable Kit includes replacement thermal material.
Description
Cable Kit
Before removing the RJ-45 (network) jack, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4.
Remove the battery (see
5.
Remove the following components:
a.
Switch cover and keyboard (see
b.
Memory module (see
c.
Optical drive (see
d.
Speakers (see
e.
Palm rest (see
f.
WLAN module (see
g.
Hard drive (see
Battery on page
42).
Switch cover and keyboard on page
Memory module on page
Optical drive on page
Speakers on page
50)
Palm rest on page
51)
WLAN module on page
Hard drive on page
53)
Spare part number
535757-001
46)
48)
56)
Component replacement procedures
43)
77
Advertisement
Table of Contents
