Roll Paper Cannot Be Inserted Into The Paper Feed Slot; Cannot Load Sheets; Paper Is Not Cut Neatly; Paper Is Not Cut - Canon imagePROGRAF iPF6400 Basic Manual

iPF6400
3
Press the OK button.

Roll paper cannot be inserted into the paper feed slot

Roll paper cannot be inserted into the paper feed slot
The roll paper is warped.
Paper is jammed by the paper feed slot.
After a roll was advanced, the paper was manually pulled out by force, closing
the Paper Feed Slot.

Cannot load sheets

Cannot load sheets
Cause
The paper source selection is incorrect.

Paper is not cut neatly

Paper is not cut neatly
Cause
The paper is bent or curled at the cut position.
Paper rises by the ends of the cut position before
it is cut.
You are using paper that cannot be cut with the
Cutter Unit.
Cut Speed is not configured correctly in the Con-
trol Panel menu.
During cutting, printed documents fall out at an
angle.

Paper is not cut

Paper is not cut
The printed document became caught on a foreign object by the
Output Tray, which lifted the document. The Cutter passed under
the paper.
In the printer driver, No or Print Cut Guideline is specified in
Automatic Cutting.
In the Control Panel menu, Cutting Mode is set to Eject or Man-
ual.
Basic Guide
Cause
Corrective Action
Press the Load button and select the paper source.
Straighten out any curling by the edges of the paper.
Reload the paper correctly.
Specify Manual in Cutting Mode in the Control Panel menu and use scissors or a
cutting tool to cut the roll after printing.
(See "Specifying the Cutting Method for Rolls.")
Change the Cut Speed setting in the Control Panel menu.
(See "Menu Structure.")
In the Control Panel menu, set Cutting Mode to Eject. Hold documents after print-
ing, as they are cut.
(See "Specifying the Cutting Method for Rolls.")
Cause
Roll paper cannot be inserted into the paper feed slot
Straighten out curls and reload the roll.
Remove the jammed paper.
(See "Clearing Jammed Roll Paper.")
(See "Clearing a Jammed Sheet, Fed Manually.")
Remove the roll and open the paper feed slot.
(See "Removing the Roll from the Printer.")
Corrective Action
→P.55
Corrective Action
Remove the foreign object by the Output Tray to enable the printer to
eject the printed document, keeping it level.
Specify Yes in Automatic Cutting in the printer driver.
If the Cutting Mode is Eject, press the Cut button to cut the paper.
If the Cutting Mode is Manual, cut rolls with scissors or the like.
Corrective Action
→P.91
→P.94
→P.14
→User's Guide
→User's Guide
97