Troubleshooting
The camera does not emit
any sound.
The Frame function does
not erase the frame.
The ERASE ALL function
does not erase all the frames.
Can't format the xD-Picture
Card.
When the camera is connected
to a personal computer (PC),
the shot image appears on the
camera's LCD monitor.
Nothing happens when I
use the Mode switch.
The camera no longer
works correctly.
Possible causes
i The camera volume is set too low.
i The microphone was blocked during
shooting/recording.
i There is something covering the speaker
during playback.
i DPOF settings are specified for some
frames.
i Some frames may be protected.
The xD-Picture Card is write-protected.
i The special FinePix 3800 USB cable is not
properly connected to the computer or
camera.
i The PC is not switched on.
i Camera malfunction.
i The batteries exhausted.
The camera has suffered an unforeseen
problem.
Solutions
i Adjust the volume.
i Take care not to block the microphone
during shooting/recording.
i Ensure that the speaker is uncovered.
i Cancel the DPOF settings and try again
(➡P.70).
i Remove the protection.
Remove the write-protection.
(Peel off the write-protect sticker.)
i Set up the camera and the special FinePix
3800 USB cable correctly.
i Switch the PC on.
i Briefly remove the batteries or disconnect
the AC power adapter. Then reload the
batteries or reconnect the AC power adapter
and try again.
i Replace the batteries.
Briefly remove the batteries or disconnect the
AC power adapter. Then reload the batteries
or reconnect the AC power adapter and try
again.
127