Sharp CD-BA250 Operation Manual page 15

7
Press the / ( ) button to start playback.
z Playback will begin from track 1 on the disc you have selected to play. After
that disc finishes playing, the next disc will automatically start playback.
z When the last track on the third disc has finished playing, the CD player will
stop automatically.
z When there is no CD in one of the disc 1 - 3 positions, that position will be
skipped and the next CD will be played.
To interrupt playback:
Press the CD button on the remote control.
To resume playback from the same point, press the
To stop playback:
Press the (CD ) button.
To remove the CDs:
Whilst in the stop mode, press the OPEN/CLOSE button.
The disc tray will open. Remove the two discs. Then, press the DISC SKIP button to
rotate the disc tray and remove the remaining disc.
After use:
Press the ON/STAND-BY button to enter the power stand-by mode.
Caution:
z Do not place two CDs in one disc tray.
z Do not push the disc tray whilst it is moving.
z Do not turn the disc tray by hand. This may cause malfunctions.
z If the power fails whilst the tray is open, wait until the power is restored.
z If the disc tray is stopped forcibly, "ER-CD10" will appear in the display and the unit
will not function. If this occurs, press the ON/STAND-BY button to enter the power
stand-by mode and then turn the power on again.
z If TV or radio interference occurs during CD operation, move the unit away from
the TV or radio.
z If a disc is damaged, dirty, or loaded upside down, the disc will be skipped.
„ To locate the beginning of a track
To move to the beginning of the next track:
Press the
To restart the track being played:
Press the
Notes:
z You can locate the beginning of a track on a single disc only.
z The
beginning of a track.
button.
„ To locate the desired portion
For audible fast forward:
Press and hold down the
For audible fast reverse:
Press and hold down the
Notes:
z Normal playback will resume when the
button is released.
z You can locate the desired portion on a single disc only.
z When the end of the last track is reached during fast forward, "END" will appear on
the display and CD operation will be paused. When the beginning of the first track
is reached during fast reverse, the disc will start playback automatically.
z The
desired portion.
PRESET button for less than 0.5 seconds during playback.
z You can skip to any track by pressing the
PRESET
the desired track number appears.
PRESET button for less than 0.5 seconds during playback.
z You can skip to any track by pressing the
PRESET
the desired track number appears.
/ or / button on the remote control allows you to locate the
PRESET button during playback.
PRESET button during playback.
/ or / button on the remote control allows you to locate the
button repeatedly until
button repeatedly until
PRESET or PRESET
ENGLISH E-14