Entering Characters - Sharp ZQ-290 Operation Manual

Entering Characters

Moving the Cursor
Move the cursor by pressing j, l, k, or m .
Entering Characters
Entering letters and numbers
The initial setting for entering letters is small (lowercase) letters. To
enter capital (uppercase) letters, turn "CAPS" on by tapping $.
Touch Keyboard
Alphabet entry mode
• Each time f is tapped, the touch keyboard switches between the
Alphabet entry mode and the Number entry mode.
To tap the touch keys, use the stylus (included in the package).
• Tap towards the center of each key.
Other characters
Tap s to display the symbol entry mode, allowing a total of 32
symbols and characters to be selected. To select the desired
symbol/special character, tap s the appropriate number of
times at the position where you would like to insert it.
Characters assigned to s :
Number entry mode
Making Corrections
1. Inserting or Overwriting characters
Tap i, once or twice, to insert or overwrite characters.
2. Deleting characters
c can be used for deletion of data in Calculator mode and Rate
figure in Conversion mode.
d can be used for deletion of characters.
d can also be used to delete listings.
Loop Function
Right after the power is turned on, function modes can be browsed
through; every time < key is pressed, the function modes will
sequentially be displayed as below:
Home Clock ➠ World Clock ➠ Personal ➠ Business ➠ Other ➠
Schedule ➠ Memo ➠ ...
Pressing the > key will display the above menus in the reversed
order.
Press x to select a desired mode; the Organizer will then escape
from the Loop function.
5