4-28 Configuring Your Server
Operating Procedures for Setup Utility
Creating/Adding Configuration
Set new configuration information (pack/logical drive settings)
1.
Run LSI Logic Software RAID Setup Utility.
Select "Configure" → "New Configuration" from the TOP menu (Management Menu).
Select "View/add Configuration" to add configuration.
IMPORTANT:
Creating a configuration using "New Configuration" menu clears
the existing configuration information. To add configuration
information to the existing configuration, select "View/add
Configuration."
You cannot create Spanning of RAID1 or set the logical drive
capacity on "Easy Configuration" menu.
Use "New Configuration" or "View/Add Configuration" instead.
Run LSI Logic Software RAID Setup Utility
Check the logical drive settings
Initialize logical drive
Perform Consistency Check
Exit LSI Logic Software RAID Setup Utility