3-10 Setting Up Your Server
Hang either clip of a cage nut on a square hole on the rack and insert another clip into the hole by
using a tool such as a flat tip screwdriver.
NOTE:
Installing the Rail Assemblies
Make sure of the right side rail assembly or the left one when installing it. See the figure below.
1.
Loosen a screw securing the rail assembly.
Front
2.
Align the front and rear frames of rail assembly to the location where the cage nuts are
installed.
Locate the rail assembly so that the frame of the rack is located between cage nuts and
frames of rail assembly.
NOTE:
located in front of the rack frame.
Confirm that all the cage nuts are installed at the level.
Confirm that the portion of the frame to fix the rail assembly is
Rear
Screws
Screws