Navman Tracker 5507 Installation And Operation Manual page 22

3-2-1 Chart modes
The Chart has two modes:
Centre on boat mode
To switch to centre on boat mode in the chart
window, press
of the chart. As the boat moves through the
water, the chart automatically scrolls to keep the
boat in the centre of the chart. The cursor (see
below) is turned off.
Cursor mode
The keys and
To switch to cursor mode in the chart window,
hold down a cursor key. The cursor
and moves away from the boat:
Press the key which points in the direction
that the cursor will move, for example press
to move the cursor down.
Press midway between two of the cursor keys
to make the cursor move diagonally.
Hold a cursor key down to make the cursor
move continuously across the display.
In Cursor mode:
The distance ( DST) and bearing ( BRG) of
the cursor from the boat are displayed at the
bottom, left corner of the display.
The chart does not scroll as the boat moves.
If the cursor reaches the edge of the display,
the chart will scroll.
For example, hold down
cursor to the right side of the display and the
chart will scroll to the left.
3-2-2 Latitude and longitude
Latitude and longitude can be displayed in
the data header. The display is degrees and
minutes to three decimal places, about 2 m (6
ft) resolution. Normally the position is the boat's
position, and the latitude and longitude has a
boat symbol to show this:
36° 29.637' N or S
175° 09.165' E or W
If the cursor has been moved in the last ten
seconds, then the position is the cursor's position,
and the latitude and longitude has a cursor
symbol to show this:
36° 29.841' N or S
175° 09.012' E or W
22
. The boat is at the centre
are called cursor keys.
appears
to move the
Latitude
Longitude
Latitude
Longitude
NAVMAN TRACKER 5507/5607 Installation and Operation Manual
CAUTION
!
WARNING
!
When reading the boat position, make sure
DANGER
the position is not the cursor position.
3-2-3 Chart scale
CAUTION
Press to zoom in and display a smaller area of
the chart in more detail. Press
and display a bigger area in less detail.
The chart scale is displayed at the top left of the
chart:
3-2-4 Chart symbols and information
The chart will show symbols, such as waypoints
and chart symbols (for example buoys, beacons,
wrecks and marinas). When the cursor is placed
over a symbol for at least two seconds, a data
window appears at the bottom left of the display
with information about the symbol.
To see stored information about a point on the
chart (for example, a chart symbol):
1 Move the cursor to that point on the chart.
2 Press and select Chart info.
3 A menu of objects is displayed:
i Select an object to display.
ii Press to return to the menu. Select
other objects.
iii Finally, press
3-2-5 Finding a chart symbol
To find and display a chart symbol:
and select Find.
1 Press
2 Select the type of symbol: Waypoints, Routes,
Ports by name, Ports & services, Tide stations
or AIS Vessels.
3 For Ports & services: select the type of service
to find.
For Ports by name: press
enter a name or letters contained in the port
name, then press
4 A list of items is displayed. If there are more
items than will fit on the display, press
to page up and down.
to zoom out
to return to the chart.
, , or
.
to
or