Navman TRACKFISH 6500 Installation And Operation Manual page 22

3-2-1 Chart modes
The Chart has two modes:
Centre on boat mode
To switch to centre on boat mode in the chart
display, press
of the chart. As the boat moves through the
water, the chart automatically scrolls to keep
the boat in the centre of the chart. The cursor
(see below) is turned off.
Cursor mode
The keys and
keys. To switch to cursor mode in the chart
display, hold down a cursor key. The cursor
appears and moves away from the boat:
Press the key which points in the direction
that the cursor will move, for example press
to move the cursor down.
Press midway between two of the cursor
keys to make the cursor move diagonally.
Hold a cursor key down to make the cursor
move continuously across the display.
In Cursor mode:
The distance ( DST) and bearing ( BRG)
of the cursor from the boat are displayed at
the bottom corner of the display.
The chart does not scroll as the boat moves.
If the cursor reaches the edge of the
display, the chart will scroll.
For example, hold down
cursor to the right side of the display and
the chart will scroll to the left.
3-2-2 Latitude and longitude
Latitude and longitude can be displayed in
the data header. The display is degrees and
minutes to three decimal places, about 2 m
(6 ft) resolution. Normally the position is the
boat's position, and the latitude and longitude
has a boat symbol to show this:
36° 29.637' N or S
175° 09.165' E or W Longitude
If the cursor has been moved in the last ten
seconds, then the position is the cursor's
position, and the latitude and longitude has a
cursor symbol to show this:
36° 29.841' N or S
175° 09.012' E or W Longitude
22
. The boat is at the centre
are called cursor
to move the
Latitude
Latitude
Warning: When reading the boat
position, make sure the position is not the
cursor position.
3-2-3 Chart scale
Press
of the chart in more detail. Press
out and display a bigger area in less detail.
The chart scale is displayed at the top left of
the chart:
3-2-4 Chart symbols and information
The chart shows many kinds of symbols,
such as waypoints, ports, marinas, buoys and
beacons. If necessary, press or
to choose a chart scale where the symbol is
displayed.
To see stored information about a symbol:
1 Either move the cursor to the symbol on
the chart and wait two seconds
or use Find to move the cursor to a symbol
for a port or service (see section 3-2-5).
2 A window appears at the bottom of the
display with some information about the
symbol.
3 To see more detail about a symbol or a list
of associated items for the symbol, press
i Select an item to display. If there are
more items than will fit on the display,
press
Select a camera icon to display a photo
of the item. If the photo is too big to fit
on the display, press
scroll the photo.
Select Tide Height Station to
display a tide chart for the position (see
section 13).
ii Select other items or press
return to the chart.
To see stored information about nearby
symbols press
info. Then follow step 3 above.
NAVMAN
to zoom in and display a smaller area
:
or to scroll up or down.
and select Chart
TRACKFISH 6500 Installation and Operation Manual
to zoom
or
, , or to
to