Replacing The Gas Valve - Frymaster YSCFC24GSERIES YSCFC24GSERIES Service & Parts Manual

5. Reverse the above steps for reassembly.

1.6.3 Replacing the Gas Valve

Drain the frypot or remove drain valve handle to prevent accidental opening before
1. Disconnect fryer from electrical and gas supplies.
2. Disconnect the wires from the gas valve terminal block, marking each wire to facilitate
reconnections.
3. Remove the high-limit thermostat wire from the gas valve coil (CE only).
4. Remove gas lines and pipe union collars from the gas valve and remove the valve.
5. Remove the pipefitting from the old gas valve and install on the replacement valve, using
Loctite PST567 or equivalent pipe thread sealant on threads. Do not apply sealant to the
first two pipe threads. Doing so will clog and damage the gas valve.
6. Reverse steps 1-5 to install the replacement gas valve.
1.6.4 Replacing Direct-Spark Ignitor Assembly (Units with Electronic Ignition Only)
1. Remove the burner shield from the
burner-box slots.
2. Disconnect sense wire and ignition
cable from the ignitor.
3. Remove the mounting screw from the
ignitor mounting-bracket and remove
the ignitor.
4. Reverse the procedure to replace the
ignitor assembly. Ensure the ignitor
is properly positioned in relation to
the center burner before tightening
mounting screw.
NOTE: The above procedure is
applicable to fryers equipped
with electronic ignition systems
only.
YSCFC SERIES FLATBOTTOM GAS FRYERS
CHAPTER 1: SERVICE PROCEDURES
proceeding further.
DANGER
Ensure ignitor is properly positioned (arrow) over
the center burner prior to tightening the mounting
screw.
1-9