Frymaster YSCFC24 Series Installation & Operation Manual page 14

3.7 SYSTEM INSTALLATION INSTRUCTIONS
1. This system consists of a 2424G fryer with a
built-in filter and an additional fryer that will
be attached to it. The additional fryer may
be a 24G, an 1824G or a 2424G. If the
additional fryer is an 1824G, the 18-inch
frypot must be in the outside position, as
shown in the illustration below.
These frypots must mate.
24
18 24
The 24-inch frypots must mate with each other.
18-inch frypots, if present, must always be to
the outside of the battery.
2. Prior to removing the fryers from their
pallets, open the doors of the 2424G with the
filter remove the filter pan (Fig. 1). Remove
the fryers from the pallets by lifting them up
and over the pallet supports. Avoid damage
to the casters and caster support bases
when lifting and placing fryers.
All connection hardware (bolts, nuts, etc.) is
included in the shipping bag.
3. Remove the upper and lower back panels (Fig.
2, arrows) of the cabinets to be joined. Set the
screws and back panels aside for later
reassembly. Place a rubber boot on the end of
the filter unit's drainpipe.
4. Position the cabinets within 6 inches of each
other, close to the area where they will be
installed. Do not push the cabinets together at
this time. Connect the wires exiting the
cabinets to be joined (Fig. 3). The 1824G oil-
return switches will not work if these wires are
not connected.
5. Slowly push the two systems together. Adjust
the front casters to align the cabinets vertically.
Ensure the drainpipe on the connecting unit and
the rubber boot on the main unit are aligned.
The drainpipe should slide into the rubber boot;
do not push the drainpipe all of the way in. Feed
the yellow and red wire connections evenly
through each cabinet wire hole as the cabinets
are pushed together. Ensure the wire
connections go inside the wireway, and are not
pinched between the cabinets.
These frypots must mate.
24
24 18
Filter Unit
Figure 1. Retainer latches securing filter
Figure 1. Remove the filter pan by
pan.
pulling it out from underneath the
fryer.
Figure 2. Remove all of the screws at
each location to remove cabinet backs.
Figure 3. Wires connecting oil return
switches.
3-4