Table of Contents
Advertisement
Before each use inspect the cover to ensure the cover gasket is present and
properly placed. DO NOT use the disposal unit if this gasket is damaged or
missing.
3. Slowly open the drain valve. Regulate flow with the drain valve to prevent splashing.
DO NOT OVERFILL! Do not fill the reservoir above the fill lines on the sides of the
reservoir. Moving the MSDU with an overfilled reservoir may result in spills and
injury to personnel who come in contact with the spilled oil.
4. Carefully withdraw the unit far enough to allow the cover to be closed. Latch the cover in the
closed postion. Using the handle, carefully tip the unit back slightly for ease of handling and roll
the unit to the disposal site.
DO NOT use the pump or discharge piping assembly as a handle!
To minimize the potential for burns, oil must always be allowed to cool below 100°F
(38°C) before draining into the MSDU and transporting to the disposal area.
However, DO NOT allow oil to congeal in the MSDU.
The unit is designed to be moved, when properly filled, at an average walking pace on a flat
surface. Care must be taken at all times when moving hot oil. Rough terrain or sudden stops
and starts may cause the contents of the reservoir to spill or splash out of the reservoir,
possibly causing serious injury to personnel. Always ensure that the cover is latched shut
when moving the unit.
5. At the disposal site, lift the pump assembly lock pin and rotate the discharge pipe as necessary to
position the discharge nipple over the opening of the disposal container. Release the lock pin to
secure the pump assembly in position. Turn the pump handle clockwise. The pump should start
discharging oil after a few turns. Continue turning the handle until the MSDU reservoir is empty.
NOTE: The pump is NOT self-priming. If it has not been used for several days, it may have lost
its prime and may need to be re-primed in accordance with Step 3 of Section 2.2.
DANGER
DANGER
WARNING
DANGER
4
Advertisement
Table of Contents
