Technical Specifications - JBL Soundzone SMS1 Owner's Manual

Specifications
POWER CAPABILITY
SPL Capability (1W, 1m):
Music (use only one of the following):
Internal Crossover:
Remote Volume Control Jack:
Protected Controls
Subwoofer Polarity:
Page Threshold:
User Accessible Controls:
SMS1-WH/230
SMS1-SUB-WH
SMS1-SUB/230
SMS1-SUB-WH/230
OPTIONAL ACCESSORIES:
Z-M1 Paging Microphone:
ZR-V Remote Wallplate:
ZR-IWB In-Wall Electrical Box:
ZR0OSB On-Surface Electrical Box:
Note 1: If positioning of the Subwoofer requires the use of a long unbalanced (RCA) input cable for the
music, then buffering and/or balancing of the signal via an external device at the source might be
necessary in order to make sure the audio fidelity is not compromised before getting to the SMS1 system.
19
SMS1-Sub: 80 Watts Continuous pink noise
160 Watts Continuous program
240 Watts Continuous peak
SMS1-Sat: 10 Watts Continuous pink noise (x 4 speakers)
20 Watts Continuous program (x 4 speakers)
40 Watts Continuous peak (x 4 speakers0
104 dB average, 108 dB peak.
SMS1-Sub:
92 dB average, 98 dB peak (x 4 speakers)
SMS1-Sat:
INPUTS
Pro Line Level Input: +4 dBu nominal, balanced, Euroblock connector
Consumer Line Level Input: =10 dBV nominal, unbalanced, RCA connector.
(See Note 1, below if using the Consumer Line Input)
Speaker Level Input: For 70V or 100V speaker lines, Euroblock connector
Microphone: Balanced, Euroblock connector, switchable phantom power for condenser
microphones. Band limited 200 Hz – 8 kHz
24 dB/oct low-pass to the subwoofer amp/driver.
24 dB/oct high-pass to the satellite amp/speakers.
RJ45 connector, for standard UTP Category 5 cable. Uses ZR-V remote wallplate.
SETTINGS
Sets the polarity of the input signals so the bass to the subwoofer adds properly.
Positions:
In Polarity (Normal)
Out of Polarity.
Sets the crossover frequency of the subwoofer.
Crossover: Positions:
160 Hz (Normal) – for normal operation of SMS1 system.
80 Hz – when using SMS1 Sub to augment the bass of another speaker
Adjusts subwoofer level relative to that of the satellite speakers.
Bass Trim: Control: Variable rotary control
AutoWarmth automatically adjusts tonal balance to sound full at low volumes.
Indicator: LED, lights when AutoWarmth is activated.
AutoWarmth:
Control: Variable rotary control
Adjusts threshold where microphone signal triggers music ducking.
Built-in EQ is specifically set up for SMS1-Sats.
Speaker EQ: Positions: On (Normal), Off
Adjusts volume of music source
Music:
Mic: Adjusts volume of the paging microphone
MODELS:
SMS1 Charcoal Gray, 120 VAC
SMS1-WH White, 120 VAC
Charcoal Gray, 230 VAC
SMS1/230
White, 230 VAC
SMS1-SUB Powered Subwoofer, Charcoal Gray, 120 VAC
Powered Subwoofer, White, 120 VAC
Powered Subwoofer, Charcoal Gray, 230 VAC
Powered Subwoofer, White, 230 VAC
Dynamic (leave phantom power off), 600 ohms, balanced
Wallplate for remote adjustment of music volume
U.S. Size electrical box for use with ZR-V. For countries where U.S. size boxes
are not be available. Contains side dogear clamps to clamp onto wall surface.
U.S. Size electrical box for use with ZR-V. For countries where U.S. size boxes
may not be available. Mounts on the surface of the wall.
system, to avoid muddy overlap with fullrange speakers.