Network - Samsung BD-D5900 User Manual

Setup
BD Data Management
Enables you to manage the downloaded contents
from a Blu-ray Disc that supports the BD-LIVE
service.
You can check the device information including
the storage size, delete the BD data or change the
Flash memory device.
Change Device allows you to select either the
product's Internal Memory or External Memory
(connected USB Device).
If the data to be stored from BD-LIVE is greater
than the size of the remaining memory or the
Internal Memory is full, connect an External USB
device, then select External Device in the menu.
Settings
Display
BD Data Management
Audio
Current Device
System
Total Size

Network

Available Size
Language
Delete BD Data
Security
Change Device
General
Support > Move
Description of Device(Storage) Information on
the Product
• Current Device : Displays the current device.
• Total Size : Displays the total size of the device.
(Storage)
• Available Size : Displays the available size of
the device. (Storage)
• Delete BD Data : Press this to delete the BD
data.
• Change Device : Press this to change the
device.
NOTE
✎
` The total size of BD Data Management may differ,
depending on the conditions.
42
English
: Internal Menory
: 579 MB
: 579 MB
\
: Internal Menory
" Enter ' Return
Network
To begin setting up the network connection for
your product, follow these steps:
1. In the Home menu, press the ◄► buttons
to select the Settings, and then press the
ENTER button.
2. Press the ▲▼ buttons to select Network, and
then press the ENTER button.
Settings
Display Network Settings
Audio Network Status
System BD-Live Internet Connection : Allow(Valid Only)
Network
Language
Security
General
Support
3. Press the ▲▼ buttons to select Network
Settings, and then press the ENTER button.
4. Press the ▲▼ buttons to select Network
Type, and then press the ENTER button.
5. Press the ▲▼ buttons to select Wired or
Wireless, and then press the ENTER button.
6. Go to the next section.
Network Settings
Please contact your ISP to find out if your IP
address is static or dynamic. If it is dynamic, we
recommend using the Auto setting. This is the
easiest and will work in the majority of cases. If it is
static, you must use the manual set up procedure.
Directions for wired networks are below. Directions
for wireless networks are after the directions for
wired networks.
Wired Network
1. In the Network Settings menu, press the ▲▼
buttons to select Network Settings, and then
press the ENTER button.
The Internet Protocol Setup screen appears.
2. Press the ► button, then select Auto or
Manual, and then press the ENTER button.