Table of Contents
Advertisement
Disassembly and Assembly Instructions
11-2 Assembly
1
Solder SPK/MOT
Solder SPK/MOT
1) Solder SPK/MOT and check the polarity
(Be careful about Short Circuit)
3
Install LCD
1) Install LCD
2) Put on SPK/MOT on Lower Case after twist them 2
times.
(Be careful about scratch and damage)
This Document can not be used without Samsung's authorization
Put on SPK/MOT,
after Twist them
2 times.
SAMSUNG Proprietary-Contents may change without notice
2
Install CON TO CON and Camera
1) Connect CON TO CON.
2) Connect Camera FPCB.
3) Put on Cam Holding Tape
(Be careful about scratch and damage)
4
Construct Upper Case Ⅰ
1) Construct Lower Hook at the Upper Case first.
(Be careful about scratch and damage)
11-4
Advertisement
Table of Contents
