Xerox DocuPrint C2100 User Manual page 70

Item
Adobe Protocol
Parallel Settings
Specifies the settings for the parallel interface.
Note
• You need to restart the printer to activate the new settings. After making the settings, turn off the printer
and then turn it on again.
Item
Bi-directional
Adobe Protocol
70
4 Setting on the Control Panel
Sets the PostScript communication protocol.
• [Auto] (default)
Automatically detects the PostScript communication protocol.
• [Standard]
Select this when the communication protocol is in ASCII format.
• [BCP]
Select this when the communication protocol is in binary format.
• [TBCP] Select this when the communication protocol are both in ASCII and binary
formats and switches between the two using control codes.
• [Binary]
Select this when no special processing is required for data.
Note
• The DocuPrint C2100 does not support [Adobe Protocol].
• Select an appropriate option according to the data format specified on your printer
driver.
• [Adobe Protocol] is valid only when printing in PostScript.
Specifies the Bi-directional communication mode of the parallel interface.
• [Enable] (default)
The Bi-directional communication mode is enabled.
• [Disable]
The Bi-directional communication mode is disabled.
Sets the PostScript communication protocol.
• [TBCP](default)
Select this when the communication protocol are both in ASCII and binary formats
and switches between the two using control codes.
• [Binary]
Select this when no special processing is required for data.
• [Auto]
Automatically detects the PostScript communication protocol.
• [Standard]
Select this when the communication protocol is in ASCII format.
• [BCP]
Select this when the communication protocol is in binary format.
Note
• The DocuPrint C2100 does not support [Adobe Protocol].
• Select an appropriate option according to the data format specified on your printer
driver.
• [Adobe Protocol] is valid only when printing in PostScript.
Description
Description