Drawer Kick-Out Connector (Modular Connector) - Epson TM-T81 Technical & Specifications Manual

Confidential

2.2.3 Drawer Kick-out Connector (Modular Connector)

The pulse specified by ESC p or DLE DC4 is output to this connector. The host can confirm the
status of the input signal by using the DLE EOT, GS a, or GS r commands.
1) Pin assignments: See Table 2.2.2.
Table 2.2.2 Drawer Kick-out Connector Pin Assignments
Pin Number
+24 V is output through pin 4 when the power is turned on. However, pin 4 must be used only
for the drawer.
2) Connector model:
3) Drawer kick-out drive signal
Output signal:
CAUTION: To avoid an overcurrent, the resistance of the drawer kick-out solenoid must be 24
or more.
Output waveform:
Figure 2.2.3 Drawer Kick-out Drive Signal Output Waveform
EPSON
Signal Name
1 Frame GND
2 Drawer kick-out drive signal 1
3 Drawer open/close signal
4 +24 V
5 Drawer kick-out drive signal 2
6 Signal GND
Figure 2.2.2 Drawer Kick-out Connector
Printer side: MOLEX 52065-6615 or equivalent
User side: 6-position 6-contact (RJ12 telephone jack)
Output voltage:
Output current:
Outputs the waveforms in Figure 2.2.3 to the points A and B in
Figure 2.2.4.
t1 (ON time) and t2 (OFF time) are specified by ESC p or DLE DC4.
t1 x 2 ms
t 1x 2 msec
TITLE
TM-T81
Specification
(STANDARD)
Direction
—
Output
Input
—
Output
—
1 6
Approximately 24 V
1 A or less
t2 x 2 ms
t 1x 2 msec
SHEET
REVISION
A
NO
NEXT SHEET
19 18