Table of Contents
Advertisement
Using the Remote Control
Remote Control
Functions
On/Standby
This section explains how to use the remote control.
The wireless remote control that comes with the Polaview 330 LCD
projector is similar to a remote control for a television or VCR. Use the
remote control to set up and adjust the image settings and to control
interactive presentations.
On/Standby
Source
Menu
Direction keys
Joystick
Left mouse
Figure 17: Remote Control
Use the projector control buttons on the remote control to control
projector functions. Use the built-in joystick and the mouse buttons to
remotely control the computer mouse.
For more information on how to configure the remote mouse, see
"Configuring the Remote Mouse" on page 28.
This section describes the projector functions that you can control from
the remote control. Functions that are also available from the projector
keypad are noted.
Press the On/Standby button on the remote control (Power On/Standby
button on the projector keypad) to change the projector operating state.
If the projector is in the sleep state , press the On/Standby button to
change the projector to the live state . If the projector is in the live state ,
and the lamp has been on for more than 30 seconds, press the On/
Standby button to change the projector to the standby state . If the lamp
has been on for less than 30 seconds, the projector changes to the standby
pending state prior to changing to the standby state.
For more information on the projector's operating states, see "Operating
States" on page 14.
Using the Remote Control
Curtain
Freeze
Zoom In
Zoom Out
Pointer
Audio controls
Drag
Right mouse and
remote backlight
English
15
Advertisement
Table of Contents
