Remote Management; Tools; Restart - Planet WRT-405 User Manual

System Name: Displays the name given to the WRT-405.
System Location: Displays the location of the WRT-405 (normally, the DNS name).
System Contact: Displays the contact information for the person responsible for the
WRT-405.
Community: SNMP system name for exchanging SNMP community messages. The name
can be used to limit SNMP messages passing through the network. The default name is
"public".
Trap Receiver: Type the name of the destination PC that will receive trap messages.

3.6.2 Remote Management

This screen enables you to set up remote management. Using remote management, the WRT-405 can
be configured through the WAN via a Web browser. A user name and password are required to perform
remote management.
HTTP: Enables you to set up HTTP access for remote management.
Enable: Click to enable or disable HTTP access for remote management.
Remote IP Range: Type the range of IP addresses that can be used for remote
access.
Telnet: Enables you to set up Telnet access for remote management.
Enable: Click to enable or disable Telnet access for remote management.
Remote IP Range: Type the range of IP addresses that can be used for remote
access.
Allows to Ping WAN Port: This function allows remote users to ping WRT-405 WAN port
IP address.
Enable: Click to enable or disable WAN port pinged function.
Remote IP Range: Type the range of IP addresses that can ping from remote
locations.

3.7 Tools

3.7.1 Restart

Click Restart to restart the system in the event the system is not performing correctly.
- 24 -