Led Indicators; Chapter 2 Hardware Installation; Hardware Connection - Planet WRT-405 User Manual

Before you proceed with the installation, it is necessary that you have enough information about the
WRT-405.

2.1 Hardware Connection

1. Locate an optimum location for the WRT-405. The best place for your WRT-405 is usually at
the center of your wireless network, with line of sight to all of your mobile stations.
2. Adjust the antennas of WRT-405. Try to adjust them to a position that can best cover your
wireless network. The antenna' s position will enhance the receiving sensitivity.
3. Connect RJ-45 cable to WRT-405 LAN port. Connect one of the LAN ports on WRT-405 to your
LAN switch/hub with a RJ-45 cable.
4. Connect RJ-45 cable to WRT-405 WAN port. Connect ADSL/Cable Modem to the WAN port on
WRT-405. Use the cable supplied with your modem. If no cable was supplied with your modem,
please use a RJ-45 Ethernet cable
5. Plug in power adapter and connect to power source. After power on, WRT-405 will start to
operate.
Note: ONLY use the power adapter supplied with the WRT-405. Otherwise, the product may be
damaged.
Note: If you want to reset WRT-405 to default settings, press and hold the Reset button over 5
seconds. And then wait for 10 seconds for WRT-405 restart.

2.2 LED Indicators

Chapter 2 Hardware Installation

- 3 -