Table of Contents
Advertisement
Problem
Camera turns off
without warning.
Monitor is blank.
Monitor is hard to read.
Date and time of
recording are not
correct.
No indicators displayed
in monitor.
Print date not
available.
Cause/Solution
• Battery is exhausted.
• The camera automatically turns off to save
power if no operations are performed for an
extended period of time
• The camera and battery may not work properly
at low temperatures.
• The camera turns off if the Charging AC Adapter
is connected while the camera is on.
• The camera turns off if the USB cable connecting
it to a computer or printer is disconnected.
Reconnect the USB cable.
• The internal temperature of the camera is high.
Leave the camera off until it has cooled and then
turn it on again.
• Camera is off.
• Standby mode for saving power: press the
power switch, the shutter-release button,
A button, c button, or b (e movie-record)
button.
• When flash lamp flashes, wait until flash has
charged.
• Camera and computer are connected via USB
cable.
• Camera and TV are connected via audio/video
cable.
• Adjust monitor brightness.
• Monitor is dirty. Clean monitor.
• If camera clock has not been set, "Date not set"
indicator flashes during shooting and movie
recording. Images and movies recorded before
clock is set are dated "00/00/0000 00:00" or "01/
01/2013 00:00" respectively. Set the correct time
and date from the Time zone and date option
in the setup menu.
• The camera clock is not as accurate as ordinary
watches or clocks. Periodically compare the time
of the camera clock with that of a more accurate
timepiece and reset as required.
Auto info is selected for Photo info in Monitor
settings in the setup menu.
Camera clock has not been set.
Troubleshooting
A
22
E75
F3
18
76, 79,
E30
–
23
23, E75
55
76, 79
76, E27
88, E68
F5
24, E65
25, E65
88, E68
24, E65
F7
Advertisement
Table of Contents
