By Map Input; Showing The Map Of Current Position - Acura 2007 MDX Navigation Manual

By Map Input

After you select Map Input from the
Enter destination by screen, the
display changes to:
NOTE:
• Prior to departure, you can set areas
to avoid. The system then includes
them in its calculations for the
destination you have entered. See
Edit Avoid Area on page 96.
• For information on the available
voice commands, see Voice
Command Index on page 140.
Showing the Map of Current
Position
The Current Position selection
assumes that you are looking for a
destination in the immediate area. The
display changes to:
The red arrow indicates your vehicle
position. Find your desired destination
by moving the Interface Dial left,
right, up, or down. The map and cross
hairs will move in the same direction.
If desired, rotate the Interface Dial
knob to change the map scale. When
you have the cross hairs on the desired
icon, map feature, or road. Then push in
on the Interface Dial. The address of
the road segment will appear at the top
of the screen.
Entering a Destination
The yellow box indicates the area you
will see when you click on the current
map with the Interface Dial.
NOTE:
The address of the road segment will be
displayed on the 1/20, 1/8, 1/4, or 1/2
mile (80, 200, 400, or 800 m) scale map.
If this is the desired destination, push in
on the Interface Dial again. If not, use
the Interface Dial to reposition the
cross hairs, then push in on the
Interface Dial again to display the new
address.
Once you select an address, the system
then displays the Calculate route to
screen (see Driving to Your Destination
on page 50).
Navigation System
45