Time Adjustment; Vehicle; Off-Road Tracking - Acura 2007 MDX Navigation Manual

Time Adjustment

Adjusts the current time in hours and
minutes. Switch HOUR and MINUTE
by moving the Interface Dial left or
right, and change value by rotating the
Interface Dial knob. Selecting
DONE returns you to the previous
screen. You can reset the adjustment by
selecting RESET.
NOTE:
Selecting RESET also clears any
changes you made to "Auto Daylight"
or "Auto Time Zone" settings.
Depending on your location, you may
need to adjust these settings.

Vehicle

From the Setup screen (second), say or
select Vehicle and the following screen
appears:

Off-road Tracking

With this ON, the system will provide
white off-road tracking dots
("breadcrumbs") on the map screen
whenever you drive into an area where
the map does not show any roads. See
Map Screen Legend on page 20.
System Set-up
After you have traveled approximately
1/2 mile away from a mapped road, the
system will display a series of white
dots on the map screen to show the path
you have traveled. This is provided so
you can follow the dots to backtrack to
the mapped road you originally left.
Tracking continues until you reach a
mapped road. See Off-road Tracking on
page 67.
Tracking is shown only in the 1/20, 1/8,
1/4, and 1/2 mile, or the 80, 200, 400,
and 800 meter scales. Rotate the
Interface Dial knob to change the
scales if necessary.
NOTE:
To clear existing dots, turn this feature
off and exit Setup. To re-enable this
feature, return to Setup and turn it on
again.
Navigation System 101