Acura 2007 MDX Navigation Manual page 130

Problem
The daytime map screen is dark like the night display mode,
and it is hard to see. Why?
During the day, I turned on the lights because it started to
rain, but the screen went dark. How can I make it still display
day mode?
How can I input my destination using map coordinates?
How do I change or remove my PIN?
I forget the PIN. How do I reset it?
I change my setup settings, but they are not saved when I
restart the vehicle.
I cannot access my Calendar or Address Book. Why?
CALL is not available on the Calculate route to screen.
Why?
Verify the following: The display mode in Setup is set to Day mode, and
Map Color in Setup is set to White for Day. See Switching Display Mode
on page 104.
Adjust the dash brightness (+) knob to full brightness. Remember to set it
back to a medium setting, or at night, the screen will be bright. See
Switching Display Mode on page 104.
The navigation system was not designed for this. However, you can view
the coordinates of an address by pushing in on the Interface Dial, selecting
Show Icon on Map, and moving the Interface Dial left to select
Current Location. See Displaying Current Location on page 21
Go to "Personal Information" in the Setup screen (second), and select PIN
Number. Enter your existing PIN, and then you have the choice to change
or remove the PIN. See page 88.
PINs are optional. See information regarding PINs on page 88. Your dealer
can reset the PIN for you.
Verify that your Remote Keyless Entry is linked (The MID shows
"Welcome drive 1" or "Welcome driver 2"). See page 18 for additional
information.
Your phone is not "paired" to the HFL, or if your phone is "paired," it is in
use; press HFL BACK button.
Frequently Asked Questions
Solution
Navigation System 129