Demostration Mode; Switching On; Switching The System To Standby Mode; Plug And Play - Philips FW-C220 User Manual

Notes:
– PLUG and PLAY will be reinitiated again during
the next power up if :
i) PLUG and PLAY installation was not completed.
ii) No stereo frequency being detected during
PLUG and PLAY, "CHECK ANTENNA" will be
displayed.
– You can store any radio stations manually or
automatically after PLUG and PLAY.
– When PLUG and PLAY is used, all previously
stored radio stations will be replaced.
– During PLUG and PLAY, if no button is pressed
within 15 seconds, the system will go to
demonstration mode (if demonstration mode is
enable)
Demonstration mode
The system has a demonstration mode that
shows the various features offered by the system.
To disable the demonstration mode
Press and hold Ç (on the system only) for 5
seconds when the system is in demonstration
mode.
"DEMO OFF" is displayed.
The system will switch to standby mode.
To enable the demonstration mode
Press and hold Ç (on the system only) for 5
seconds when the system is in standby mode.
The demonstration will begin.
Notes:
– If the demonstration mode has not been disabled,
it will resume 5 seconds later after the system
switches to standby mode.
– When the system is switched on from the main
power outlet, the CD changer tray may open and
close again to initialize the set.
– Even though the AC power cord is removed from
and reconnected to the wall socket, the
demonstration will remain off until it is switched on
again.
12
pg 01-28/C220/22-Eng
Operating the System
Switching the system ON
¶ Press CD, TUNER, TAPE or AUX.
¶ Press STANDBY-ON in demo.
You can also switch on the system by pressing
any one of the CD DIRECT PLAY buttons (on
system only).
Switching the system to standby
mode
¶ Press STANDBY-ON or B on the remote
control.
The system will switch to standby mode.

Selecting the Source

¶ Press the respective source selection button: CD,
TUNER, TAPE or AUX.
The display indicates the selected source.
Note:
– For an external source, make sure you have
connected the audio left and right OUT terminals
of the external equipment (TV, VCR, Laser Disc
player, DVD player or CD Recorder) to the AUX IN
terminals.

DIM mode

You can select the desired brightness for the
display.
¶ Press DIM to select DIM 1, DIM 2, DIM 3 or
DIM OFF display mode.
The
"DIM 1", "DIM 2", "DIM 3" or "DIM OFF"
will be displayed depending on the mode
selected.
DIM OFF - normal brightness with
Spectrum Analyzer On
12
display lights up.
DIM
3139 115 20671
12/7/00, 1:43 PM