Demostration Mode; Switching On; Switching The System To Standby Mode; Switching The System To Eco Power Mode - Philips FW-C380 User Manual

Notes:
– PLUG and PLAY will be reinitiated again during
the next power up if :
i) PLUG and PLAY installation was not completed.
ii) No stereo frequency being detected during
PLUG and PLAY, "CHECK ANTENNA" will be
displayed.
– You can store any radio stations manually or
automatically after PLUG and PLAY.
– When PLUG and PLAY is used, all previously
stored radio stations will be replaced.
– During PLUG and PLAY, if no button is pressed
within 15 seconds, the system will go to
demonstration mode (if demonstration mode is
enable)
Demonstration mode
The system has a demonstration mode that
shows the various features offered by the system.
To disable the demonstration mode
Press and hold Ç (on the system only) for 5
seconds when the system is in demonstration
mode.
"DEMO OFF" is displayed.
The system will switch to standby mode.
To enable the demonstration mode
Press and hold Ç (on the system only) for 5
seconds when the system is in standby mode.
The demonstration will begin.
Notes:
– If the demonstration mode has not been disabled,
it will resume 5 seconds later after the system
switches to standby mode.
– When the system is switched on from the main
power outlet, the CD changer tray may open and
close again to initialize the set.
– Even though the AC power cord is removed from
and reconnected to the wall socket, the
demonstration will remain off until it is switched on
again.
pg 01-30/C380/22-Eng
Operating the System
Switching the system ON
¶ Press CD, TUNER, TAPE or AUX.
You can also switch on the system by pressing
any one of the CD DIRECT PLAY buttons.
Switching the system to standby
mode
¶ Press STANDBY-ON or B on the remote
control.
The system will switch to standby mode.
Switching the system to ECO
POWER standby mode
Demonstration mode is stopped)
¶ Press ECO POWER or press and hold B on
the remote control for more than 2 seconds to
switch to eco power standby mode (< 2 watts).
"ECO PWR" will be displayed, after which the
display screen goes blank.
The ECO POWER LED will be lit.
To switch on the system from ECO
POWER mode
¶ Press ECO POWER.
The system will switch to last selected source.
¶ Press CD, TUNER, TAPE or AUX on the
remote control
The system will switch to the selected source.
Note:
– If the demonstration mode has not been
disabled, it will resume 5 seconds later.
13
(when
3139 115 20641
12/7/00, 3:42 PM
13