Input Selection And Av Connections; Input Signal Selection - Toshiba RV55* Digital Series Owner's Manual

Defining the INPUT and OUTPUT sockets so that the television recognises connected equipment. See page 7
for a clear view of the back connection recommendations.
Most media recorders and decoders send a signal
through the SCART lead to switch the television to the
correct Input socket.
Alternatively press the external source selection button
until the picture from connected equipment is shown.
B
This button must be used to view equipment connected
using the COMPONENT VIDEO INPUT (EXT3C).
An S in the display e.g. 2S (EXT 2S), indicates the
B
input is set for an S-Video signal.
Input Selection
At any time by pressing
1
screen showing modes and all stored external
equipment. Use and
e
select.
DTV
1
B
2
B
3
B
HDMI1
HDMI2
HDMI3
PC
ATV
NOTE: When in digital mode ATV cannot be
selected, in analogue mode DTV cannot be
selected. To switch between DTV and ATV press
the A/D button.
HDMI displays equipment connected to HDMI on
the back of the television.
PC displays a computer connected to RGB/PC on
the back of the television.
Input selection and
AV connections
B
a list will appear on
to highlight and OK to
f
DTV
1
B
2
B
3
B
HDMI1
HDMI2
HDMI3
PC
ATV
39

INPUT Signal Selection

This specifies the type of signal going into SCART 2 (EXT2)
on the back of the television. Please refer to the
manufacturers instructions for the connected equipment.
In the SET UP menu press
1
AV connection is highlighted, then press OK.
SET UP
Language
Country
Auto tuning
Manual tuning
AV connection
Picture position
Back Watch TV
MENU EXIT
With or select either AV or S-VIDEO as the
z x
2
required input for EXT2.
AV connection
PC/HDMI1 audio
HDMI1 audio
HDMI setting
EXT2 input
Woofer
Back Watch TV
MENU EXIT
If the colour is missing try the alternative setting.
until
e
1/2
English
UK
OK
OK
OK
OK
PC
Digital
AV
Internal