Table of Contents
Advertisement
Controls and input connections
A wide variety of external equipment can be connected to the input sockets on the side of the television.
Whilst all the necessary adjustments and controls for the television are made using the remote control, the
buttons on the television may be used for some functions.
POWER switch
Auto Contrast Sensor – see page 27
(Full Power Down Option)
Switching on
If the RED LED is unlit check that the mains plug is connected
to the power supply and press the
left side of the television. If the picture does not appear press
on the remote control, it may take a few moments.
i
To put the television into Standby press
control, the GREEN active standby LED will appear
(see 'Software Upgrade' section) next to the RED for a few
moments then disappear. To view the television press
again. The picture may take a few seconds to appear.
I
NOTE: When the
/
POWER switch is turned off, the digital
i
channel position you previously viewed may not be
memorised in the television memory.
Using the Remote Control
Press the MENU button on the remote control to see
the menus.
In digital mode the menu bar at the top of the screens will
show three different topics shown in symbols. As each
symbol is selected by pressing the
remote control, its respective options will appear below.
In analogue mode the menu appears as a list of five topics.
As each symbol is selected by pressing the
the remote control, its respective options will appear below.
GREEN LED – Active standby
(digital only)
I
/
POWER button on the
i
on the remote
i
i
or
button on the
z
x
or
button on
z
x
12
Standby
RED LED – Standby
GREEN LED – Power on
Conditional Access Module (CAM).
To use the options press the
f
control to move up and down through them and OK,
or
to select the required choice. Follow the on screen
x
instructions. The functions of each menu are described in
detail throughout the manual.
Using the Controls and Connections
To alter the volume press —
j
To alter the programme position press
Press MENU and S , R , Q or P to control the sound and
picture options.
Press MENU twice to finish.
When connecting sound equipment to EXT3, connect the
audio output of the equipment to the phono sockets on the
television.
B
until the display shows EXT3
To select the Input, press
as described on page 39. The television will automatically
sense the type of signal.
Please always refer to the owner's manual of the equipment
to be connected for full details.
Please note: Inserting the headphone plug will mute the
sound from all speakers.
HDMI3
INPUT
INPUT 3
(EXT3)
Headphone jack
COMMON INTERFACE
The Common Interface is for a
Contact a service provider.
and
button on the remote
e
z
+
.
e e
f f
.
F
Advertisement
Table of Contents
