Configuring Jmicron Jmb362/Gigabyte Sata2 Sata Controller - Gigabyte GA-890XA-UD3 User Manual

5-1-2 Configuring JMicron JMB362/GIGABYTE SATA2 SATA Controller

A. Installing SATA hard drive(s) in your computer
Attach one end of the SATA signal cable to the rear of the SATA hard drive and the other end to available
SATA port on the motherboard. See the table below for the SATA controllers and their corresponding SATA
ports. Then connect the power connector from your power supply to the hard drive.
B. Configuring SATA controller mode in BIOS Setup
Make sure to configure the SATA controller mode correctly in system BIOS Setup.
Step 1:
Turn on your computer and press <Delete> to enter BIOS Setup during the POST. In BIOS Setup, go to Inte-
grated Peripherals. To enable RAID, see the table below for configuring different SATA Controllers for RAID.
Controller Connectors
JMicron eSATA ports
JMB362
GIGABYTE GSATA2_6/7
SATA2
CMOS Setup Utility-Copyright (C) 1984-2010 Award Software
OnChip SATA Controller
OnChip SATA Type
x OnChip SATA Port4/5 Type
x OnChip SATA RAID5 Support
OnChip SATA 3.0 Support
Onboard GSATA Controller
Onboard GSATA Mode
Onboard ESATA Controller
Onboard ESATA Mode
Onboard LAN Function
Onboard LAN Boot ROM
 SMART LAN
Onboard Audio Function
Onboard 1394 Function
Onboard USB 3.0 Controller
Onchip USB Controller
USB EHCI Controller
USB Keyboard Support
USB Mouse Support
Legacy USB Storage
Onboard Serial Port 1
higf: Move Enter: Select
F5: Previous Values
Step 2:
Save changes and exit BIOS Setup.
The BIOS Setup menus described in this section may differ from the exact settings for your moth-
erboard. The actual BIOS Setup menu options you will see shall depend on the motherboard you
have and the BIOS version.
BIOS Settings
Set Onboard ESATA Controller to Enabled
Set Onboard ESATA Mode
Set Onboard GSATA Controller
to
Set Onboard GSATA Mode
Integrated Peripherals
[Enabled]
[Native IDE]
IDE
Enabled
[Enabled]
[Enabled]
[RAID/IDE]
[Enabled]
[RAID]
[Enabled]
[Disabled]
[Press Enter]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[Disabled]
[Enabled]
[3F8/IRQ4]
+/-/PU/PD: Value F10: Save
F6: Fail-Safe Defaults
Figure 1
- 81 -
to
RAID
to
Enabled
RAID/IDE
Item Help
Menu Level 
ESC: Exit F1: General Help
F7: Optimized Defaults
Appendix