Gigabyte GA-8IG1000 User Manual page 98

Qu esti on 4: Ho w do I cl ear C MO S?
Answer: If your board has a Clear CMOS jumper, please refer to the Clear CMOS steps in the
manual. If your board doesn't have such jumper, you can take off the on-board battery to leak
voltage to clear CMOS. Please refer to the steps below:
Steps:
1. Turn off power.
2. Disconnect the power cord from MB.
3. Take out the battery gently and put it aside for about 10 minutes (Or you can use a
metal object to connect the positive and negative pins in the battery holder to make
them short for one minute).
4. Re-insert the battery to the battery holder.
5. Connect power cord to MB again and turn on power.
6. Press Del to enter BIOS and load Fail-Safe Defaults.
7. Save changes and reboot the system.
Qu est io n 5 : W hy d oe s s ys te m s ee m un sta bl e af ter u pd ati ng B IO S?
Answer: Please remember to load Fail-Safe Defaults (Or Load BIOS Defaults) after flashing
BIOS. However, if the system instability still remains, please clear CMOS to solve the problem.
Que stion 6: Wh y do I stil l get a wea k soun d aft er tur ning u p the speak er to the m aximu m volu me?
Answer: Please make sure the speaker you are using is equipped with an internal amplifier. If not,
please change another speaker with power/amplifier and try again later.
Qu esti on 7 : H ow do I dis abl e onb oar d VGA ca rd in or der to a dd an ex ter nal VG A car d?
Answer: Gigabyte motherboards will auto-detect the external VGA card after it is plugged in, so
you don't need to change any setting manually to disable the onboard VGA.
Qu est io n 8 : W hy c an not I u se th e ID E 2?
Answer: Please refer to the user manual and check whether you have connected any cable that
is not provided with the motherboard package to the USB Over Current pin in the Front USB
Panel. If the cable is your own cable, please remove it from this pin and do not connect any of your
own cables to it.
GA-8IG1000 Pro/GA-8IG1000 Motherboard - 94 -