Installation Instructions - Daewoo DWF-200M Instruction Manual

DWF-200/240M(101) 97.1.19 4:21 PM ˘ ` 4
INSTALLATION IN STRUCTIONS
Location of washer
Check location where washer will be installed. Make sure you have everything
necessary for correct installation.
Proper installation is your responsibility.
•
Do not place or store your washer below 0
•
Install the washer on the horizontal solid floor.
C
SOAK
FEED
FUZZY
BLANKET
WOOL
NIGHT
HEAVY ECO.
A
A
UP DOWN
Drain system
Never forget to install drain hose before operating your washer.
The packing box is opened, there are a drain hose, and a hose clamp in the washer.
Non-Pump Model
• Connect the drain hose to the drain outlet
at the back of the washer, and fasten
it tightly with the clamp attached.
NOTES
• The opening must not be obstructed by carpeting when the washing machine is
installed on a carpeted floor.
˚
C (32
If the washer is installed on an unsuitable floor, it could
make considerable noise, vibration and cause a malfunction.
If washer is not level, adjust the front leg(A) up or down for
horizontal setting.
•Earthed electrical outlet(B) is required with 20cm of
B
bottom back of washer cabinet.
•Hot and cold water faucets (C) must be within 1M of the
upper back of the washer cabinet and provide water
pressure 0.3kgf/cm
Hose clamp Drain hose
˚
F) to avoid any damage from freezing.
2 -8kgf/cm 2 (29.4kPa-784.5kPa).
Pump Model
• Connect the drain hose to the drain outlet
at the back of the washing machine,
and fasten it tightly with the clamp
supplied.
Drain hose
4
Drain Outlet
Hose Clamp