Descriptions Of Control Panel; General Procedures For Operation - Daewoo DWF-6010AP Instruction Manual

DESCRIPTIONS OF CONTROL PANEL

°°
HIGH
MID
POWER
LOW
DELAY
Power Switch
POWER
Press this button to turn the power ON or OFF.
Water Level Selector
This button is used to select the water level you want.
Delay Button
If you want to delay the finishing time of the wash, use this button.
As this button is pressed, digit in display increases by 1hour per one press.
If current time is 8:00 am and you wish washing to be completed around 5:00
pm, press this nine times in order to display '9'.
Cycle Selector
This button is used to select the washing course according to the type of wash
loads.
Either Wool or Suit course is adopted to your Washing Machine.
Program Button
With this button, you can create new cycle by combining processes.
Temperature Selector (optional)
If your washer is connected to two water taps for cold water and hot water, you can select
the water temperature. Default operation, cold water will be selected automatically.
Start/Hold
START
With this button, you can make your washer proceed your program, or stop temporarily.
/ HOLD
And you can also release the temporary stop by pressing this.
11
FUZZY ADD
HOT/COLD
START
LIGHT WASH
WARM/COLD
/ HOLD
HEAVY RINSE COLD/COLD
WOOL SPIN

GENERAL PROCEDURES FOR OPERATION

1. Add measured detergent to the washer, (Follow manufacturer's directions for safe use)
2. OPTIONAL STEP
If desired, add measured liquid chlorine bleach to the bleach inlet. use only liquid chlorine in
the bleach inlet
* Follow manufacturer's direction for safe use.
NOTE
• Do not let bleach splash, drip, or run down into washer
basket.
Undiluted bleach will damage any fabric it touches.
• Do not use this dispenser to add powdered chlorine or
color safe bleach to your wash load. The dispenser is for
Bleach inlet
liquid chlorine bleach use only.
(Symbol)
3. OPTIONAL STEP
If desired, add measured liquid fabric softener to the softener inlet.
• Pour liquid fabric softener into the dispenser using the amount recommended on the
package. Avoid dripping or spilling any fabric softener on the load.
• The dispenser is for liquid fabric softener use only.
4. Close the washer lid (door)
5. Press the power button.
6. Select the cycle. The full automatic cycle has four settings; FUZZY, LIGHT, HEAVY, SUIT.
(See page 9)
7. Press the "START/HOLD" button.
12
Softener inlet
(Symbol)