NETGEAR MBR1210 User Manual page 9

Mobile Broadband 11n Wireless Router MBR1210 User Manual
Table 1. LED Descriptions
LED Activity
Power Solid green
Solid amber
Off
Internet Port Solid green
Solid amber
Blinking green
Blinking amber
Blinking green and amber Failover from WAN to Mobile Broadband.
Off
Wi-Fi
Solid blue
Blinking blue
Off
LAN Ports Solid green
Blinking
Off
WAN Port Solid green
Blinking
Off
2G/3G Solid blue
Solid green
Off
Signal Quality Solid blue
Solid green
Solid amber
Off
Restore Factory Locate the small hole outlined in red on the back of the router. Insert a paperclip into the hole
Settings and push for 6 seconds. Depressing the reset button causes the LED to blink briefly. After the
button is held down for more than 6 seconds, the LED will flash AMBER, and then turn green
as the router resets to the factory defaults. See
Description
The router is turned on and operating normally.
POST (power-on self-test) in progress.
Power is not supplied to the router.
There is an Internet session.
Traffic meter limit has been reached, traffic is blocked.
Data is being transmitted over the Internet connection.
Traffic meter limit has been reached, but traffic not blocked.
No Internet connection detected.
The Wi-Fi local port is initialized.
Data is being transmitted or received over the Wi-Fi link.
The wireless access point is turned off.
The local Ethernet ports have detected wired links with PCs.
Data is being transmitted or received.
No link is detected on these ports.
The Ethernet WAN port has detected an active link.
Data is being transmitted or received.
No link is detected on these ports.
Indicates the router is in 3G+ coverage.
Indicates the router is in 2G coverage.
No coverage is detected.
Excellent coverage detected.
Good coverage detected.
Marginal coverage detected.
No coverage detected.
Chapter 1. Connecting to the Internet | 9