NETGEAR MBR1210 User Manual page 78

Select the radio button of the static route you want to configure.
2.
Click Add or Edit to display the following screen:
3.
Fill in or change the fields:
4.
Route Name. The route name is for identification purposes only.
•
Private. Select this check box if you want to limit access to the LAN only.
•
The static route will not be reported in RIP.
Active. Select this check box to make this route effective.
•
Destination IP Address, and IP Subnet Mask. If the destination is a single host, type
•
a subnet value of 255.255.255.255.
Gateway IP Address. This must be a router on the same LAN segment as the router.
•
Metric. Type a number between 2 and 15. This represents the number of routers
•
between your network and the destination. Usually, a setting of 2 or 3 works, but if this
is a direct connection, set it to 2.
Click Apply to save your changes. If you added a static route, it is added to the Static
5.
Routes screen.
78 | Chapter 5. Advanced
Mobile Broadband 11n Wireless Router MBR1210 User Manual