Continuous Irradiation; Irradiation Using An External Start Signal - Panasonic UJ30 Series User Manual

3) Continuous irradiation

Irradiation using the EMISSION switch of the controller
The displayed The The The displayed values displayed displayed
(1) Starting irradiation
(2) Stopping irradiation

4) Irradiation using an external start signal

Irradiation can be started externally using the INPUT terminals on the rear of the controller—either
"START ALL" or "START1-4."
(1) Starting irradiation
(2) Stopping irradiation
values apply values values apply to to to to the apply apply the the flashing the
1. Select the channel/s for irradiation.
2. Press the EMISSION switch
(Irradiation will start on all channels indicated by red lights. The
EMISSION switch glows red during irradiation.)
3. While irradiation is in progress press the EMISSION switch
again. (Irradiation will stop on all channels.)
1. Turn on the START signal.
(Irradiation is activated under the conditions summarized below.)
Start signal
setting
PULSE
STATUS
○･･･Irradiation starts when the start signal is switched from OFF
●･･･Irradiation starts when the start signal is switched from
Case of START ALL: When the START ALL signal is turned ON
Case of START1-4:
2. Switch the STOP signal to ON.
(Irradiation can also be stopped by pressing the EMISSION switch.)
flashing flashing channel. flashing channel. channel. channel.
INPUT terminal
START ALL
○
●
to ON. (Duration is per timer setting.)
OFF to ON, and stops with an OFF signal (at "Con"
setting)
irradiation
selected channels.
When the signal of a START No. terminal is
switched ON
corresponding CH No.
Operation modes
START1-4
○
●
starts simultaneously
irradiation starts
on all
on the
15