Getting started
5.4 Connecting the AC adapter
5.5 Power-on operation
12
Plug the connector of the supplied AC adapter into the AC adapter connector on
the rear panel. To ensure that the controller is completely disconnected from t
he power supply, unplug this connector.
Only connect the power plug end of the AC adapter to a power socket after
the controller is fully set up.
The supplied power cable is a 100 V (AC) cable for use in Japan.
To start up the controller, insert the supplied power key into the power key switch
and turn it clockwise.
When the power is turned on a beep will sound and the display will indicate
startup status. The display will then change to operation mode (under the default
setting).