Using System Functions From The Outside (Disa: Direct Inward System Access) - Siemens HiPath Series Operating Instructions Manual

Step by Step
Using System Functions from the Outside
(DISA: Direct Inward System Access)
If this function has been configured (contact your serv-
ice personnel), you can set up external outgoing calls
from outside the system, just like an internal user. You
can also activate and deactivate the following functions
in your system:
• Reset services and functions,
code: #0
• Call forwarding, code:
• Lock and unlock all phones,
code: 66/#66
*
• Save PIN,
code: 93
*
• Send a message,
code: 68/#68
*
• Leave an advisory message,
code: 69/#69
*
• Group ringing, code:
• Group call, code:
• Suppress caller ID,
code: 86/#86
*
• Waiting tone, code:
• Open door, code:
• Door opener on/off, code:
• Control relay, code:
• Do not disturb, code:
• Ringer cutoff function, code:
• Speed-dialing, code:
• Associated service, code:
Precondition: You have a telephone that uses tone di-
aling (DTMF dialing) or you can switch your telephone
to tone dialing. The telephone is not connected to the
system.
o
Set up a call to the system. Enter the station number
(contact your service personnel).
o
Wait for a continuous tone (if necessary switch the tel-
ephone to tone dialing), then enter the internal number
that has been assigned to you and the associated PIN.
r
Enter the code (necessary only if programmed in the
system).
Page 79
1/#1
*
Page 69
Page 71
Page 72
Page 74
81/#81
*
85/#85 Page 87
*
Page 67
87/#87
*
61 Page 32
*
89/#89
*
90/#90
*
97/#97
*
98/#98
*
7 Page 37
*
83
*
Using Other Functions
Page 21
Page 87
Page 47
Page 32
Page 85
Page 66
Page 66
Page 80
81