Toshiba V200 Series User Manual page 88

SW046 Ladder Scan Time
S0034 Ladder Instruction Error
Status
Configuration Words and coils
Register / Coil Tag Name
MW0000 PLC Operation Mode
(Bit 0 to Bit 3)
MW0001 Error Register 1
MW0002 Error Register 2
MW0003 RUN/STOP Switch Control
(Retentive)
MW0005 Digital Filter constant
MW0010 Configuration Register for
Special inputs
MW0011 Configuration Register for
PWM output
MW0012 Preset values for high Speed
MW0013 Counter
MW0014
MW0015
MW0016 Count Values for high Speed
Counter
MW0017
MW0018
MW0019
MW0020 High Speed counter
control flags
MW0021 Special output control flags
MW0022 Special Output Control Flags Read/Write
MW0023
MW0024 Special output Frequency
Setting
MW0025
MW0030 System Timer Coils
MW0031 User Interrupt program Status
Flags
MW0033 Unit IP Address Lo Word
MW0034 Unit IP Address Hi Word
MW0035 Unit Subnet Mask Address
Lo Word
MW0036 Unit Subnet Mask Address
Hi Word
MW0037 Unit Default Gateway
Lo Word
MW0038 Unit Default Gateway
Hi Word
M00016 CPU error
M00017 I/O error
M00018 Program error
Read only Value is multiple of 0.1 mSec
Read/Write Set if Division by zero operation is performed in
the ladder instruction and for invalid conditions or
operands in case of conversion instructions.
Read / Write Description
Bit0-3: 0: Initialization 1: HALT Mode 2: RUN
Read/Write
Mode 3: RUN-F Mode 4: HOLD Mode 6: ERROR
Mode.
Read Only Refer mapped coils M16 to M31
Read Only Refer mapped coils M32 to M47
Read Only 1: HALT, 0: RUN. Only LSB is used. other bits (1
to 15) are not used.
Read/Write Enabled when MW10 bit 16 is ON.
(0 to 15 mS)
Read/Write Refer Special input - output section
Read/Write Refer Special input - output section
Read/Write Used to set the preset values for high speed
counter
Read/Write Preset count values of the high speed counters
are stored
Read/Write Control flags for high speed counters
Read/Write Refer Special input - output section
Control flags for high speed counters
Read/Write Refer Special input - output section
Read Only Refer mapped coils M00480 to M00487
Read Only Bit 0 for timer ,Bit 1 for IO1, Bit 2 for IO2. Refer
mapped coils M496,M497 & M498
when MW10 bit 16 is ON.
Read Only Used for Ethernet Model
Read Only
Read Only
Read Only
Read Only
Read Only
Read Only ON at error state
Read Only ON at error state
Read Only ON at error state. This group includes Ladder
Scan time.
Page 80