Vauxhall Alarm System Monitors; Light Emitting Diode (Led); Switching System On Excluding Monitoring Of The Passenger Compartment And The Vehicle Tilt - Vauxhall Corsa Owner's Manual

Vauxhall alarm system
3
monitors
z the doors, sliding doors, tailgate
the bonnet,
z the passenger compartment,
z vehicle tilt, e.g. if it is raised,
z the ignition.
To activate:
All doors, windows and sun roof 3 must be
closed; press button p on the remote
control unit again within 10 seconds after
locking
– or –
turn key in driver's door lock towards rear
of vehicle again within 10 seconds after
locking, then turn it back to the vertical
position and remove.
Switching system on excluding
monitoring of the passenger
compartment and the vehicle tilt
e.g. if animals are to be left in the vehicle.
1. Close tailgate and bonnet.
2. Press button in front of the courtesy light
(with ignition off); LED in the hazard
warning light button flashes a maximum
of 10 seconds.
3. Close doors.
4. Switch on Vauxhall alarm system. LED
lights up. After approx. 10 seconds the
system is activated, without monitoring
of the passenger compartment or vehicle
tilt. The LED flashes until the system is
switched off.

Light emitting diode (LED)

During the first 10 seconds of anti-theft
alarm system activation:
z LED lights up = Test, switch-on
delay,
z LED blinks = Door, tailgate,
bonnet open
or system error.
After the first 10 seconds of anti-theft
alarm system activation:
z LED flashes = System on,
z LED lights up for
approx. 1 second = Switch-off.
If a system fault occurs, consult a
workshop. We recommend a Vauxhall
Authorised Repairer.
53