TYAN S8212 User Manual page 32

Memory Installation Procedure
When you install the memory modules, make sure the module aligns properly
with the memory slot. The modules are keyed to ensure that it is inserted only
one way. The method of installing memory modules are detailed by the
following diagrams.
1. Press the locking levers in the direction shown in the following
illustration.
2. Align the memory module with the socket. The memory module is
keyed to fit only one way in the socket.
3. Seat the module firmly into the socket by gently pressing down until it sits
flush with the socket. The locking levers pop up into place.
To remove the memory module, simply push the latches outwards until the
memory module pops up. Then remove the module.
YOU MUST ALWAYS unplug the power connector from the
NOTE
motherboard before performing system hardware changes.
Otherwise you may damage the board and/or expansion device.
32
http://www.tyan.com