Cambridge Audio AZUR 651C User Manual page 9

Programming disc play
It is possible to program the 651C to play back in any order only the tracks
you wish to listen to.
1. Ensure that a disc is loaded. The display should show the TOC data.
2. Press the Prog button on the remote control. The Program set-up will
appear in the display (as long as the display backlight is set to 'Bright'
or 'Dim' modes). 'ST:01' will flash.
,
3. Using the 0-9 or -/-- buttons, skip to or enter the track number
that you want to program as your first track.
4. Press the button. The desired track is now programmed. The
program number automatically increases by one for the next entry.
5. Repeat steps three and four until all your desired tracks are entered.
A maximum of 30 tracks can be programmed.
6. To go back and change a programmed track, press the
to locate the desired program step. 'ST:0-' does not flash.
Press the buttons to choose the replacement track. 'ST:0-'
flashes to indicate a change of program. Press the
the new track and continue.
7. Press the Prog or button to exit.
Press the Prog button again to return to program editing. At this point
you can either press the button again to delete the program and
return to TOC display, or press the
selection.
8. When the button is pressed, 'Program Play' appears briefly on the
display and playback of the programmed tracks commences.
buttons
button to select
button to start playing your
9. You can use the Skip/Scan (
move through your programmed selection in the same way as normal
playback.
10. Pressing the button during playback will take you back to the
'Program Mode' stage. Pressing the
deletes the program.
Note:
– During programmed playback, it is possible to use the 'Remain'
function only to show the time remaining on the track playing. You
can not view the time remaining on the disc.
– Only the 'Repeat All' feature can be used during Program mode. You
are not able to repeat specific tracks in the program.
Using the set-up menu
The 651C allow the setting of some options related to Auto Play, Auto
Power Down and the digital filters used by the D/A converters.
1. Press and hold the Stop ( ) button for five seconds to open the set-
up menu.
2. Scroll through the menu (shown below) using the Skip/Scan (
buttons.
3. Press the Play ( ) button selects a sub-menu. Scroll through sub-
menu options with the Skip/Scan (
is indicated by the symbol .
4. Select an option by pressing the Play ( ) button.
5. Return to the sub-menu or exit the options menu by pressing the Stop
( ) button.
Note:
– It is not possible to access the set-up menu during disc playback.
– The Stop ( ) button on the remote control cannot be used to open
the set-up menu. Once you have accessed the menu, however, the
remote control can be used to scroll through and select sub-menu
options.
Press Stop for 5 seconds
Filter Settings Auto Play
Lin Min Steep
phase phase
Off
Off
Filter Settings
See page 10 for more information.
Auto Play Setting
If required the 651C can automatically play disks inserted into the drawer
without the Play ( ) button having to be pressed. Auto Play is simply
enabled in the menu when desired. The default setting for Auto Play is
'Off'.
Auto Power Down Setting
If desired the 651C can shut itself down if not used for a period of time.
Power down after an inactive period (no disk playback or any functions of
the player used) of 5, 10 or 15 minutes can be selected. The default
setting for Auto Power Down is 'Off' (i.e. disabled).
azur 651C
) buttons on your remote control to
button again at this point
) buttons. The default setting
Auto Power Down
On
5min 10min 15min
)
9