Quick reference 1 Switching on/off with the ON button: Switching on with the ignition being To programme the mute volume level, switched off: proceed as follows: Press ON. To keep on operating the set when the • Adjust the desired volume. When switching the set on with the ON ignition is switched off (KeyCard is in- •...
Page 5
6 Rocker switch Radio operation Tape operation Changer operation Station search Title selection (S-CPS) CD selection Down Down Fast forward Down <</>> Up/Down in short intervals when AF Fast rewind is off Title selection Stop function by pressing Upwards: Press briefly. <</>>...
Page 6
7 Display 8 KeyCard theft protection system f) lo - Seek tuning sensitivity g) I, II, T - Memory bank I, II or To operate the set it is necessary that Travelstore the KeyCard is inserted. h) 6 - Preset button (1-6) i) LD - Loudness - Stereo...
Page 7
9 MIX < TA (priority for traffic announcements) Preset Scan Press SC for approximately two sec- When “TA” lights up in the display, the Changer (CDC) operation onds until you hear a beep. system will play traffic stations only. “SCAN” and the name of the scanned Priority on/off: Press TA.
Page 8
? SRC (source) D Cassette loading slot When this function has been activated, You can switch between the different “RM” shows on the display panel. Insert the tape with side A or 1 facing audio sources radio, tape, and CDC. The radio is played back during fast up, the open side showing to the right.
Page 9
H DSC (Direct Software Control) Extra function GEO Use the DSC function to customise Separate balance and fader settings certain programmable, basic settings for traffic messages. See chapter “Ad- to suit your personal needs and prefer- justing GEO for traffic messages and ences.
KeyCard theft protection system This car radio is supplied with one KeyCard ERR” will appear in the display. In this case • Press << or >>. as standard, though it can also be operated please do not make any further adjustments. The display will switch to “CHANGE”.
Switching the audio source Short Additional Memory Optical indication for extra Using the SRC button you can switch be- (S.A.M.) security tween the following audio sources: radio, The second KeyCard available from your Flashing KeyCard tongue specialised dealer offers you the possibility tape, When the vehicle is stationary and the to read out any short information, which will...
Radio operation with RDS (Radio Data System) The Radio Data System offers you more If “SEARCH” appears in the display when If you leave the service area of the regional convenience when listening to FM radio sta- switching on the radio or recalling one of the programme tuned into, or if you would like tions.
Scrolling through the broadcast- • Press the FM button as many times ing networks (only FM) until the desired memory bank lights up in the display. You can use the << >> buttons to tune in stations of your reception area. Storing stations If several programmes of the broadcasting networks can be received, you can scroll...
Automatically storing the Scanning stored stations with To select a scanned station and switch strongest stations with Preset Scan off the Radio-Scan function: Travelstore • Press SC briefly. You can have all of the stored stations briefly If no station is selected, the scan function You can automatically store the six most scanned on all wavebands.
Switching from stereo to mono Programme type Checking the programme type of the (FM) station Use << >> to have the last selected pro- • Press PTY for approximately two sec- If reception is poor, you may get better gramme type displayed and to choose a new onds.
If the system is unable to find a station of- will be released. The station received be- PTY priority fering the selected programme type, the dis- fore starting seek tuning will be tuned in. Situation: play will show “NO PTY” and a beep tone PTY is switched on and lights up in the dis- will be released.
Receiving traffic programme stations with RDS-EON Traffic announcement priority During tape or CDC operation, the set will The abbreviation “EON” stands for En- on/off also automatically switch to the programme hanced Other Networks, meaning the offering the selected PTY within the broad- exchange of information within a radio net- If the priority for traffic announcement pro- casting network.
Adjusting the volume for traffic Switching the warning beep off announcements and the warning a) Tune into another station offering traf- beep fic information: This volume was preset at the factory, • Press the rocker switch or though you can alter the value using the •...
Tape operation Fast Forward/Rewind portion of at least three seconds between The car stereo has to be switched on. the individual titles. The unit automatically switches to tape op- eration when a cassette is inserted. Switching the tape side (autoreverse) Inserting a tape To change the tape direction during cassette •...
Scanning cassette titles with Skipping unrecorded tape por- Care notes SCAN tions with Blank Skip To avoid possible problems, we recommend You can have the cassette titles played brief- This function senses an unrecorded tape you to use C-60/C-90 type cassette tapes ly by using the scan function.
CD changer control A05 Switching to CDC operation MIX playback Selecting the display mode Make sure that at least one CD has been You can have the CD tracks played in ran- You can select the desired display mode for inserted into the magazine.
Storing the display mode Entering CD names Deleting CD names with DSC-UPDATE You can store your preferred display mode You can name up to 99 discs. which will then be active each time the ra- The specified name (e.g. VIVALDI) will then You can delete a CD name with the help of dio is switched on.
DSC programming CDC NAME Only available for CD SPEECH In future many RDS radio DSC (Direct Software Control) allows you changer playback. stations will differentiate be- to customise certain programmable, basic Use this function to name tween music and speech settings to suit your personal needs and your CDs.
Page 25
BEEP Acknowledgement tone for COLOUR READ KC To read out the KeyCard all functions which require a (Variocolour) For gradually matching the data. button to be pressed for radio illumination with the The card supplied with the more than one second. dashboard lighting.
Overview of the DSC factory SCANTIME Use this function to set the CDC UPD Use this function to delete settings scan time for the radio or CD names during CDC op- CD player from between five eration, in order to have CD NAME and 30 seconds.
Wavebands: If you would like to know the address of 87.5 – 108 MHz 531 – 1602 kHz the next Blaupunkt service centre of your area without having our service list 153 – 279 kHz at hand: 0.9 µV at 26 dB FM sensitivity: Find out your area code.