Bissell Lift-Off 3750 SERIES User Manual page 6

Attach Vacuum Hose and Tools Continued
Slide the end of the Hose Grip onto the Hose Grip
3.
Base. Place the Hose into the Hose Clip.
NOTE: The Powerfoot will not operate effectively
unless the Hose is firmly attached to the base.
Snap the Telescoping Extension Wand, Crevice Tool,
4.
and Combination Tool into storage clips as shown.
On Board TurboBrush
5.
The TurboBrush Bracket slides onto the Hanger on
the front of the Handle. Attach the Bracket by
aligning the slots with the rectangular part on the
Hanger as shown and pulling down until it is locked
into place.
Note: If you do not wish to store the TurboBrush
on your Lift-Off vacuum, the Bracket may be
hung on a wall for storage and the Hanger may
be removed from the vacuum.
Place the TurboBrush in the Bracket by aligning
the small holes near the brush roll with the tabs
at the bottom of the Bracket and snap the TurboBrush
into place.
Power Switch/Brush Switch
The Power Switch is located just below the handle
on the front of the Detachable Canister. Push the
rocker switch "ON" (I) to vacuum, and "OFF" (O)
when cleaning is complete.
The Brush Switch is located just below the handle
on the front of the Detachable Canister next to
the Power Switch. This switch turns the Rotating
Brush on and off. The Brush Switch should be in
the "ON" (I) position for normal carpet cleaning.
You may want to turn the Brush Switch "OFF" (O)
for bare floor cleaning or other delicate surfaces.
Note: Your BISSELL Lift-Off vacuum is equipped
with a special internal switch that turns the
Rotating Brush off whenever the unit is in the
Upright position.
Upright – For storage and above floor cleaning with tools.
1.
Normal Cleaning – Press the Handle Release Pedal
2.
with your foot to recline.
6
TM
(Select Models Only)