Troubleshooting - Bissell PowerForce 6564 SERIES User Manual

Troubleshooting

Vacuum cleaner won't run
Possible Causes
Power cord not plugged in
1
Blown fuse/tripped breaker
2
Vacuum cleaner won't pick up dirt
Possible Causes
Incorrect Height Adjustment
1
Hose not attached to suction opening
2
Twist 'n Snap Hose not securely attached
3
4 Crack or hole in Hose
Broken or worn Drive Belt
5
Rotating Floor Brush bristles worn
6
Rotating Floor Brush jammed
7
Clog in vacuum
8
Dirt Container full
9
Dirt Container not installed properly
10
Filters are dirty
11
Louvers missing or installed incorrectly
12
Tools won't pick up dirt
Possible Cause
Crack or hole in Hose
1
Clog in vacuum
2
12
WARNING:
To reduce the risk of injury
from moving parts and/ or
electrical shock, turn
Power Switch OFF and
disconnect polarized plug
from electrical outlet
before performing
troubleshooting checks.
Remedies
Check electrical plug
1
Check/Replace fuse or
2
reset breaker
Remedies
Adjust Powerfoot to correct
1
height setting
Grasp Quick Reach Handle and
2
firmly push Hose Wand onto the
suction opening
Make sure Twist 'n Snap Hose is
3
snapped into locked position
4 Check Hose and replace if needed
Replace Drive Belt, see pg. 10
5
Replace brush
6
Remove brush and clean debris from
7
brush ends
Clear clog, see pg. 11
8
Empty Dirt Container
9
Position correctly and lock in place
10
Check and clean Inner and Outer
11
Circular Filters, Pre-Motor and
Post-Motor Filters
Check for a clog in the tube in the
12
center of the Dirt Container, clear
and properly install Louvers
Remedies
Check Hose and replace if needed
1
Clear clog, see pg. 11
2