Contents Symbols and tools Health and safety Weight and dimensions Kit Contents and Components Installation Snow & Wind Load Legislation, recommendations and maintenance Notes...
Health and safety Use safety helmet. Danger of lightning in stormy weather Heavy load Use safety shoes. Beware of tripping Use safety harness for protection against falling. Beware of slippery surfaces Use safety gloves. Beware of high temperatures Use safety goggles. Include the collector in the lightning protec- tion device of the building.
Weight and dimensions (kg) (bar) (mm) (mm) (mm) (mm) SOL 200 P 1147 1753 2271 SOL 200 L 1753 1147 1666 SOL 250 P 1147 2187 2706 >500mm >350mm >500mm >500mm...
Kit Contents and Components Intermediate Clamp Side Clamp Bottom Bracket Top Panel Top Corner L/H Top Corner R/H Top Infill Section Side Cover L/H Side Cover R/H Middle Infill Section Bottom Section Bottom Corner L/H Bottom Corner R/H Bottom infill piece Batten Wood screw L=35mm Wood screw L=70mm...
Page 10
Hydraulic kit contents and components S1- End Cap S2- Joining Piece S3- Elbow S4- Manual Air Vent (Optional part) S5- Tee Piece (Optional part) S6- Clip S7- Plug for manual Air Vent (Optional part) S8- Auto Air Vent (Optional part) S9- 2m Pipe Kit S10- Straight Connector with Fittings S11- Temperature Sensor...
Installation -The illustrations in this manual may differ from the equipment supplied. < _ 20-55º 20-55º Prepare the roof with a weatherproof membrane (felt or alternative mate- rial) before installing the collectors. For concrete roof the supplied bat- tens must not be installed. The pa- nel and the In Roof kit are installed directly to the concrete roof.
Page 12
Installation < _ < _ ψ μ < _ ψ ≤ μ 140-180 (mm) (mm) (mm) (mm) SOL 200 P 1435 2020 SOL 200 L 1415 SOL 250 P 1185 1810 2460...
Snow and Wind Load EN1991 Design limit snow load on the ground = 2.8 kN/m² NOTE: This limit will be reduced for installations where abutments create additional risks of drifting or falling snow. The maximum wind load to be borne by the mounting structure depends on the height and geographical area of the site among other factors This structure must be installed in accordance with the provisions of the EN1991 standard.
Legislation, recommendations and maintenance LEGISLATION Please note the following instructions regarding laws, regulations and technical rules. When setting up solar energy installations, the laws and regulations at local, state, European and international level that apply to the country in question must be observed. Generally ack- nowledged technical regulations apply;...
Page 32
All goods are sold subject to our standard Conditions of Sale which are available on request. MULTIFIT A Trading Division of Baxi Heating UK Ltd (3879156) Brooks House, Coventry Road, Warwick. CV34 4LL Technical Enquiries 0844 871 1568 Website www.bdrthermea.com...