Cleaning The Door; Error Code Failure System - Baumatic BDWI640 Instruction Manual

Cleaning the door

o To clean the edge around the outside of the door, you should use
a soft, damp cloth only.
o To prevent water from penetrating the door lock or electrical
components, DO NOT use a spray cleaner of any kind.
o DO NOT use any abrasive cleaner or scouring pads on the inner
or outer surfaces, as they may cause damage to them.

Error code failure system

If your appliance senses that it is not operating correctly, then a
program indicator light may flash.
The following error codes can possibly be remedied by the customer
and the steps outlined below should be followed.
BEFORE COMPLETING
APPLIANCE, IT SHOULD BE DISCONNECTED FROM YOUR MAINS
POWER SUPPLY.
RAPID program indicator flashes.
o Longer than expected fill time.
 Check the water pressure of your mains water supply.
 Clean the mesh filter that sits in the inlet hose.
 Ensure that the inlet hose is not kinked or crushed.
 Make sure the water tap that the machine is connected to is turned
on fully.
GLASS program indicator flashes.
o The machine has sensed water in the base.
 Check that the outlet hose is not kinked or crushed.
 Check that there are no blockages in the drain hose or the drainage
system that the appliance is connected to.
ANY MAINTAINEANCE ON THE
30