FOLSOM ScreenPro SPR-2000 Installation And Operator's Manual page 7

TM
ScreenPro
Step 1: Connect ScreenPro
Connect one of the two available "Main" outputs to your projector. Note that the second main output may be
connected to a local display monitor if the projection screen is not easily viewed by the operator.
Connect the "Preview" output to a computer monitor. (Note: The preview output timing is identical to the main output.
If the main output is set to 1280 x 1024, the preview monitor must be capable of that resolution.)
Step 2: Connect Input Sources to ScreenPro
TM
ScreenPro has eight universal inputs that accept composite (NTSC & PAL), S-video, component, and computer
video sources. Connect each type of input source to ScreenPro
Format – RGB
(Typical Devices: Computers)
Source to ScreenPro
R
G
B
H
V
Format – S-Video (Y/C)
(Typical Devices: S-Video VCR)
Source to ScreenPro
Y
C
Quick Start Guide
Illustration of Typical ScreenPro
TM
to Output Devices
TM
Input Connections
TM
R/CR
G/Y
B/CB
H/C
V
TM
G/Y
B/CB
TM
Setup
TM
as indicated in the following table.
Format – YUV or Y Pr Pb (Betacam)
(Typical Devices: DVD Player or Betacam Deck)
Source to ScreenPro
Y
Pr
Pb
Y
U
V
Format – Composite/PAL (Typical Devices: NTSC/PAL VCR)
Source to ScreenPro
NTSC/PAL
TM
G/Y
R/CR
B/CB
or
G/Y
R/CR
B/CB
TM
G/Y