Video Input Connections; Video Output Connections; Main Outputs; Preview Output - FOLSOM ScreenPro SPR-2000 Installation And Operator's Manual

Video Input Connections

The video input section on the ScreenPro
YUV, S-Video (Y/C), or composite (NTSC or PAL) video signals. The connections for each input channel are made
via five BNC connectors. Connection points for each type of video signal are specified below.
Format – RGB
(Typical Devices: Computers)
Source to ScreenPro
R
G
B
H
V
Format – S-Video (Y/C)
(Typical Devices: S-Video VCR)
Source to ScreenPro
Y
C

Video Output Connections

Main Outputs

Two independently buffered Main outputs (one five wire BNC connection and one HD-15) are provided. Either of
these outputs may be used to connect to the display device used for the presentation. The second output is designed
to support a local display in the event that the operator is unable to conveniently view the presentation. Both outputs
provide RGB video signals. The operator can select the type of output sync to match application requirements.
Separate C (Composite) or separate H/V (Horizontal/Vertical) sync modes are supported.
Connect the outputs labeled R, G, and B on the rear panel of the ScreenPro
connectors on the output device. Connect the C or H/V sync signals from ScreenPro
connectors on the output device. If separate H/V sync mode is being used, be sure to connect both the H and V
signals from the ScreenPro

Preview Output

One Preview output is provided on an HD-15 connector. The Preview output is provided to permit the operator to
view the next source video to be displayed prior to initiating a transition. The Preview output provides an RGB video
signal. Connect the outputs labeled R, G, and B on the rear panel of the ScreenPro
labeled connectors on the output device.
The operator can select the type of output sync to match application requirements. Separate C (Composite) or
separate H/V (Horizontal/Vertical) sync modes are supported. Connect the C or H sync signals from ScreenPro
the correspondingly labeled connectors on the output device. If separate H/V sync mode is being used, be sure to
connect both the H and V signals from the ScreenPro
device.
Manual # 26-0002901-00 / Revision H
TM
rear panel provides eight universal inputs. Each input can accept RGB,
TM
R/CR
G/Y
B/CB
H/C
V
TM
G/Y
B/CB
TM
to the correspondingly labeled connector on the output device.
Format – YUV or Y Pr Pb (Betacam)
(Typical Devices: DVD Player or Betacam Deck)
Y
Pr
Pb
Y
U
V
Format – Composite/PAL (Typical Devices: NTSC/PAL VCR)
NTSC/PAL
TM
TM
to the correspondingly labeled connector on the output
ScreenPro - High Resolution Seamless Switcher
Source to ScreenPro
or
Source to ScreenPro
unit to the correspondingly labeled
TM
to the correspondingly labeled
TM
unit to the correspondingly
TM
G/Y
R/CR
B/CB
G/Y
R/CR
B/CB
TM
G/Y
TM
to
8