Specifications; Identification And Parts Description - Axminster AWHBS250N User Manual

Specification...
W
A X M I N S T E R
W H I T E
Axminster No.
Motor
Wheel Diameter
Blade Speed (double speed)
Max Cutting Depth:
Max Cutting Width:
Max Cutting Width with Fence:
Blade Length:
Blade Width:
Table Size:
Table Tilt:
Table Height on Bench:
Table Height on Stand:
Dust Extraction Outlet:
Overal Size L x W x H:
Noise Level
Weight
Please read the Instruction Manual prior to using your new machine; as well as the operating
procedures for your new machine, there are numerous hints and tips to help you to use the machine
safely and to maintain its efficiency and prolong its life. Keep this Instruction Manual readily
accessible for any others who may also be required to use the machine.
Please read though the section entitled Identification and Description of parts of the Saw, as this will
ensure that you will understand our references during the assembly and setting up phases.

Identification and Parts Description...

Main saw frame
upon.
Upper and lower The two doors that cover the upper and lower saw wheel compartments.
cover doors
Upper saw
wheel
12
The main body of the machine that all the other parts are mounted
There are interlocks fitted to both doors so that the machine can not
operate if either door is left open.
The upper saw wheel is mounted on double bearings on an axle that is
mounted to a tilting plate. (To provide the fore and aft tilt movement that
controls the blade tracking). The tilting plate is hinged to a yoke. The
extended ends of the hinge pin also act as guides in slots in a bracket
mounted in the rear of the upper saw wheel compartment.
AWHBS250N (211532)
240V a.c. 50Hz, 1400 rpm. 370W
660/960 M/min
6mm (1/4") to 13mm (1/2")
340 x 340mm
minus 5 to + 45˚ degrees
420 x 410 x 1500mm
<80db (A)
254mm
120mm
245mm
145mm
1790mm
370mm
990mm
63mm
43.5 kg